STEICOmulti tape F
High performance tape with special foil
- Solvent-free
- High UV and ageing resistance
- High moisture resistance/rainproof
- Can be used indoors and in UV-protected outdoor areas
- Can be processed from -10°C (dry and ice-free substrate required)
- Temperature resistant between -40 and +100 °C
Product sheet
Characteristics
| Temperature resistance [°C] | -40 to +100 |
| Processing temperature [°C] | > -10; The surface must be dry and free of ice |
| Minimum roof pitch [°] | 10 |
| Adhesive | Acrylic dispersion, solvent-free |
| Adhesive backing | UV-stabilised special film with polyester lattice, single-sided adhesion |
| Colour | Grey |
| Thickness (without release paer) [mm] | approx. 0,3 |
| Temperature range [°C] | -40 to +100 |
| UV resistance | 12 Months |
| Peeling strength | fulfilled according to DIN 4108/11 |
| Peel strength after ageing | fulfilled according to DIN 4108/11 |
Dimensions
Length [mm] |
Width [mm] |
Release liner slashing [mm] | Number/pack. [pcs.] |
|---|---|---|---|
| 25000 | 100 | 50/50 | 6 |
| 25000 | 150 | 75/75 | 4 |
| 25000 | 60 | 20/40 | 10 |
| 25000 | 60 | - | 10 |
Processing in the STEICO sheet and membrane system
- Substrates must be capable of bearing a load, dry and free from dust and grease
- Align the STEICOmulti tape F centrally, gradually remove the release liner and forcefully rub on the adhesive tape
- Split release liner facilitates the bonding of corners, as only one liner can initially be removed there
- Adhere the STEICOmulti tape F without tension and creases. The substrate must be additionally mechanically secured if tensile forces arise
- Adhesive bondings may not be located in stagnant water; adhesive bondings are also not permitted in sauna and swimming pool construction
Processing in case of STEICO wood fibre panels
- Pretreat the STEICO wood fibre panels in the adhesive area with STEICOmulti primer
- After a sufficiently long flash-off time (when primeris transparent) position the 100 mm or 150 mm-wide STEICOmulti tape F, remove release liner and rub on
- The bonding surface on the wood fibre panel must be at least 50 mm
- Additional pressing on with a paint roller or roller is recommended in order to improve adhesion
(Please refer to the product data sheet for detailed information)
Similar Products
